|
FENDER TRIM .PDF
INSTALLATION GUIDE
|
MORE RELATED INSTALLATION
VIDEOS: |
Mirror Finish
Stainless Steel Fender Trim Installation Instructions:
Welcome to Upgrade
Your Auto's installation guide. These instructions will show you how to
install Chrome Wheel Well Fender Trim.
You have two
options to install your new Fender Trim.
Option #1 is
Drill Method.
Option#2 is
Clip Method
Tools to make the Installation a little easier:
-
Clean Cloth
-
Electric Drill With
1/8" bit (when using Drill Method)
-
Screws (provided
with Fender Trim, if using Drill Method)
-
Screw Driver (if
using Drill Method)
-
Clips (when using
Clip Method)
-
Pliers (when using
Clip Method)
Option #1
Stainless Steel Fender Trim
Drill Method:
-
Wipe your
Existing Wheel Well thoroughly from any dust, dirt, grime, etc. with a clean
cloth.
-
Position Your new
Stainless Steel Fender Trim in the desired area. Using pre-drilled holes on
the Fender Trim as template, drill holes on the flange of the vehicle.
-
Insert screws
into each of the holes and tighten with a screwdriver.
-
Check to make all
screws are tighten, then clean the Fender Trim and you are Done!
Option
#2 Stainless Steel Fender Trim Clip
Method:
-
Wipe your Existing
Wheel Well thoroughly from any dust, dirt, grime, etc. with a clean cloth.
-
Pass the straight
end of the clip through one of the slots on the Fender Trim. Take the clip,
making sure the hook is securely attached to the inside metal edge of the
vehicle's Fender Flange.
-
Pull the clip from
the straight end side with pliers. Bend 180 degrees (180°)
towards vehicle's fender.
-
Press
clip flat against vehicles fender or inner mud guard Fender for a low profile
and snug fitment.
-
Then clean the
Fender Trim and you are Done!
Congratulations! You have now installed your new Chrome
Mirror Finish Stainless Steel Fender Trim. For any additional questions or to view our other chrome
product installations, check out our chrome Accessory videos and installation
guides.
|
